脐带缆螺旋滑移分析及力学性能研究   总被引：1，自引：0，他引：1  

李英  吴潘  冯雅萍  曹静萱 《海洋工程》2018,36(6):58-68

针对脐带缆内部螺旋层,应用Darboux标架建立螺旋结构空间坐标系,推导弯曲载荷下螺旋结构的局部变形和滑移。考虑螺旋构件间的接触和摩擦作用,建立螺旋结构的受力平衡偏微分方程,并研究螺旋角和摩擦系数对螺旋结构滑移的影响。基于同层螺旋结构本构关系相同假设,将所有螺旋结构力学性能线性叠加,拟合脐带缆整体弯曲刚度。运用建立的理论解析方法,对某双层铠装脐带缆的力学性能进行研究,并与数值模拟结果进行对比验证。对比结果表明,理论解析得到的螺旋滑移结果与数值模拟结果一致,理论解析得到的脐带缆弯曲刚度与数值模拟结果在全滑动阶段比较接近。  相似文献   

南海风暴潮对风场和外围海水敏感性研究     

李健  刘清容  阮成卿  訚忠辉  冀承振 《海洋科学》2018,42(2):99-107

为探索来自西北太平洋台风风暴潮与南海局地生成台风风暴潮不同,本研究在假设两种台风气象条件相同情况下,研究随台风而来外围海水所形成增水对南海沿岸的影响。以0814"黑格比"强台风风暴潮为基础,使用ROMS(regional ocean modeling system)模式进行数值模拟并通过设计对比试验方法进行研究,研究发现在台风登陆时引起的增水最大,最大增水出现在台风路径右侧,其中在沿岸区域,外围海水形成增水约占总增水10%,且大约3 h后出现增水回震现象。同时,设计对比试验,研究来自西北太平洋台风风暴潮对台风路径、台风强度、台风移动速度和流入角等气象条件敏感性,并获得与前人一致的结果。  相似文献   

基于UDF的水平轴潮流能水轮机被动旋转水动力性能研究   总被引：1，自引：1，他引：0  

陈文鹏  刘胤超  陈立卫 《海洋工程》2018,36(2):119-126

针对水平轴潮流能水轮机被动旋转问题,基于Fluent 17.0,运用UDF(User Defined Function)控制滑移网格对网格进行动态调整,仿真研究水轮机在不同安放角下被动旋转的水动力特性。通过仿真分析,结果表明:潮流能水轮机随着叶片安放角度的增加,尖速比、输出功率、捕能系数都是先增大后减小,叶片安放角为6°时,叶轮前后速度差最大,对潮流能利用充分,且各项性能均达到最佳;通过分析叶片受力,叶尖叶素在安放角为2°时阻力最大,3°时升力最大,升阻比在6°时最大,此时叶尖叶素升阻比C_L/C_D=6.27、攻角α=3.06°。由仿真结果可知水平轴潮流能叶轮的自启动过程由5个阶段组成,即加速度增大的加速运动段—加速度减小的加速运动段—加速度反向增大的减速运动段—加速度反向减小的减速运动段—稳定运行段,这对潮流能水轮机的设计具有重要的指导意义。  相似文献   

Evolutionary Processes in Low-Mass Binary Systems     

Peter P. Eggleton  Ludmila Kisseleva-Eggleton 《Astrophysics and Space Science》2005,296(1-4):327-336

We consider the evolution of certain low-mass binaries, incorporating models of (a) internal evolution, (b) tidal friction, (c) dynamo activity driven by an elementary α,Ω dynamo, (d) stellar wind driven by the activity, and (e) magnetic braking as a consequence of wind and poloidal dynamo-generated magnetic field. In some circumstances the stellar wind is found to remove mass on a nuclear timescale, as is necessary to explain some observed systems. We can hope that various uncertainties in the model may be clarified by a careful comparison of the models with such observed quantities as rotation periods. These are modified by processes (a), (b) and (e). Assuming that stellar evolution is slow, rotation rate should in some circumstances represent a balance between magnetic braking trying to slow the star down and tidal friction trying to spin it up. Preliminary attempts are promising, but indicate that some fine tuning is necessary. When there is a third body present, in an orbit which is inclined but not necessarily of short period, the eccentricity of a close binary can be strongly modified by ‘Kozai cycles’. We show that this may complicate attempts to account for spin rates of stars in close binaries.  相似文献   

三维旋转扫描测量平台设计与实现     

吴俣  叶泽田  孙立业  康永伟 《测绘科学》2009,34(6)

本设计主要用于360°旋转的三维扫描,实现角度数据的实时获取。设计中采用单片机控制交流伺服电机进行自定的角度、速度与方向的旋转并实时上传时间、角度数据至上位机进行处理,实现了对平台旋转精度的控制与检测,着重研究了该传感器误差源的产生,对实际应用中的误差进行了定量分析,利用偏心改正、4分频等方法减少了误差,提高了参数精度。角度范围为360°,角度分辨率为0.01°。  相似文献   

The shape of the rotation curves of edge-on galaxies     

A. V. Zasov  A. V. Khoperskov 《Astronomy Letters》2003,29(7):437-446

We consider the effects of projection, internal absorption, and gas-or stellar-velocity dispersion on the measured rotation curves of galaxies with edge-on disks. Axisymmetric disk models clearly show that the rotational velocity in the inner galaxy is highly underestimated. As a result, an extended portion that imitates nearly rigid rotation appears. At galactocentric distances where the absorption is low (i.e., it does not exceed 0.3–0.5^m kpc^?1), the line profiles can have two peaks, and a rotation curve with minimum distortions can be obtained by estimating the position of the peak that corresponds to a higher rotational velocity. However, the high-velocity peak disappears in high-absorption regions and the actual shape of the rotation curve cannot be reproduced from line-of-sight velocity estimates. In general, the optical rotation curves for edge-on galaxies are of little use in reconstructing the mass distribution in the inner regions, particularly for galaxies with a steep velocity gradient in the central region. In this case, estimating the rotation velocities for outer (transparent) disk regions yields correct results.  相似文献   

西安地区单桩桩土相互作用数值模拟分析   总被引：1，自引：0，他引：1  

魏静  王建华  李永林 《地球科学与环境学报》2003,25(3):63-66

随着计算机技术和数值方法的不断发展和完善,使有限元法得到越来越多的应用。根据西安地区原型摩擦桩的地层特点和土性条件,运用有限元基础理论,利用相应的边界条件与假设条件,建立单桩数学模型。通过模型研究了单桩的沉降特性与土共同作用的影响因素,对西安地区单桩桩土相互作用机理进行了探讨。  相似文献   

大地构造和海陆起源的内波假说（Ⅱ）──建立假说的大地构造学与运动学基础     

池顺良  鍾荣融  骆鸣津  杨洪之 《大地测量与地球动力学》1996,(2)

介绍建立大地构造内波假说的根据，即：（１）全球海陆分布的低阶球谐特征；（２）全球大洋中脊体系的存在；（３）大陆永存及生长的事实；（４）地壳均衡及莫霍面的化学分界面性质；（５）地槽活动的现象、规律等。在分析以在事实的基础上，研究了大地构造运动中主要的物质运动过程，认为从薄地壳底部向厚地壳底部迁移的地壳物质流，引起地壳厚度的自激波动，推动地槽运动和大陆生长。  相似文献   

The second order characteristic condition for plastic flow     

Graham Weir  Roger Young 《国际地质力学数值与分析法杂志》2003,27(15):1299-1316

In this paper the second order characteristic (discontinuous bifurcation) condition is derived for the granular flow (fully plastic) equations. This second order bifurcation equation is shown to be formally identical to the first order localization requirement during steady elastoplastic deformation provided the elastic compliance tensor is substituted for the product of the plastic multiplier with the flow Hessian. For isotropic yield and flow functions the invariant form of the characteristic condition is given in detail, as well as an alternative expression in adapted co‐ordinates. The characteristic condition can be regarded as defining a hardening function which is maximized to identify the critical angles. When the method is applied to 3D Coulomb flow, Mohr's 3D fracture plane conditions are obtained uniquely. Copyright © 2003 John Wiley & Sons, Ltd.  相似文献   

△T球体异常的三元解释法     

蔡家雄 《湖南地质》1994,13(3):155-162

在△Ｔ异常解释课题中，一个新的角度参量─—视磁化特征角的拟定，最大限度地简化了球体磁场表达式。从而才有可能通过特殊解法，给出了球体磁场的极值与拐点公式。作者据此建立了四种不受正常场制约、仅需异常的局部持征曲线即可全面解释三度异常的解释方法。屏障分解、叠加判别、三元迭代的设计，为解释三度体叠加异常给出了简单而易行的途径。  相似文献